1. Giriş
Welcome to the user manual for your new Prity K1 R Wood Stove. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your wood stove. Please read this manual thoroughly before using the appliance to ensure proper function and to prevent potential hazards.
1.1 Güvenlik Uyarıları
- Yangın Tehlikesi: Always maintain proper clearances from combustible materials. Never leave the stove unattended while in operation.
- Karbonmonoksit: Ensure adequate ventilation and proper chimney installation to prevent carbon monoxide buildup. Install carbon monoxide detectors.
- Sıcak Yüzeyler: The stove surfaces become extremely hot during operation. Use protective gloves and keep children and pets away.
- Yakıt: Only burn dry, seasoned wood. Never use flammable liquids to start or rekindle a fire.
- Chimney Maintenance: Regular inspection and cleaning of the chimney are crucial to prevent creosote buildup and chimney fires.
2. Ürün Bittiview
The Prity K1 R is a robust wood stove designed for efficient heating. It features a durable steel plate construction, a spacious firebox, and an ash pan for easy cleaning. The stove is equipped with legs for stability and a flue collar for chimney connection.
Şekil 2.1: Ön view of the Prity K1 R wood stove with a fire burning inside the firebox, showcasing the glass door and the ash pan below.
Şekil 2.2: Ön view of the Prity K1 R wood stove, showing the interior of the firebox with refractory lining and the closed ash pan.
Şekil 2.3: Arka view of the Prity K1 R wood stove, illustrating the flue pipe connection at the top and the overall steel construction.
3. Kurulum
3.1 Konum ve İzinler
The Prity K1 R wood stove must be installed on a non-combustible floor protector (hearth) that extends beyond the stove's footprint according to local building codes. Maintain the following minimum clearances from combustible materials:
- Arka: 400 mm
- Sides (Left & Right): 400 mm
- Ön: 800 mm
- Tavan: 600 mm
These clearances are critical for fire safety. Consult local regulations and a certified installer if unsure.
3.2 Baca Bağlantısı
Connect the stove to a suitable chimney system using a flue pipe with a diameter of 130 mm. Ensure all connections are sealed properly to prevent smoke leakage and ensure optimal draft. The chimney must be clean and in good condition.
3.3 First Firing (Curing Process)
During the first few fires, the paint on the stove will cure. This process may produce some smoke and odor. Ensure the area is well-ventilated during this time. Start with small fires and gradually increase the heat over several days to allow the stove to cure properly and prevent damage to the finish.
4. Kullanım Talimatları
4.1 Fuel Type
Only use dry, seasoned hardwood as fuel. Wood should be split and allowed to dry for at least 6-12 months. Burning wet or unseasoned wood reduces efficiency, increases creosote buildup, and can lead to excessive smoke. Never burn:
- Treated wood, painted wood, or particle board
- Plastics, garbage, or chemical waste
- Yanıcı sıvılar
4.2 Ateşi Yakmak
- Open the primary air intake (usually located on the ash pan door) fully.
- Place crumpled newspaper or firelighters at the bottom of the firebox.
- Stack small pieces of kindling on top of the newspaper/firelighters.
- Light the newspaper/firelighters.
- Tutuşturma çubukları iyice yanmaya başlayınca, yavaş yavaş daha büyük, kurutulmuş odun parçaları ekleyin.
- Close the firebox door once the fire is established.
4.3 Hava Kontrolü
The Prity K1 R stove features air controls to regulate the burn rate and heat output:
- Birincil Hava: Controls the air entering the firebox from below the grate, feeding the initial combustion. Open fully for starting a fire and adding new fuel. Reduce once the fire is established.
- Secondary Air (if applicable): Provides air to burn off gases above the fire, improving efficiency and reducing emissions. This may be controlled by a separate vent or integrated into the design.
- baca Damper/Throttle: A control on the chimney pipe (if installed) can be used to adjust the draft and slow down the burn rate. Use carefully to avoid excessive smoke or reduced performance.
4.4 Yakıt ikmali
When the flames have died down and only glowing embers remain, it is time to refuel. Open the primary air control, slowly open the firebox door to allow any smoke to clear, and then add new pieces of wood. Close the door and adjust air controls as needed.
4.5 Over-firing
Avoid over-firing the stove, which occurs when too much fuel is burned at too high a rate. This can lead to excessive temperatures, potentially damaging the stove and chimney, and increasing the risk of a chimney fire. If the stove glows red, it is over-firing. Reduce air intake immediately.
5. Bakım
5.1 Kül Temizleme
Regularly remove ash from the ash pan. Do not allow ash to build up to the level of the grate, as this can restrict airflow and damage the grate. Always use a metal container with a tight-fitting lid for ash disposal, and store it away from combustible materials.
5.2 Glass Cleaning
The glass in the firebox door can be cleaned when the stove is cold. Use a damp cloth dipped in fine wood ash or a specialized stove glass cleaner. Avoid abrasive cleaners that can scratch the glass.
5.3 Chimney Cleaning
The chimney and flue pipe should be inspected and cleaned at least once a year, or more frequently depending on usage and fuel type. Creosote buildup is a fire hazard. It is highly recommended to hire a certified chimney sweep for this task.
5.4 Genel Muayene
Periodically inspect the stove for any signs of wear or damage, including:
- Door seals and gaskets: Ensure they are intact and providing a good seal.
- Firebox lining (refractory bricks): Check for cracks or deterioration.
- Flue pipe connections: Ensure they are secure and free of leaks.
- Air controls: Verify they operate smoothly.
6. Sorun Giderme
| Sorun | Olası Neden | Çözüm |
|---|---|---|
| Smoke entering the room | Poor draft, blocked chimney, wet wood, door opened too quickly | Check chimney for blockages, ensure adequate air supply, use dry wood, open door slowly |
| Düşük ısı çıkışı | Wet wood, insufficient air, small fire, chimney too cold | Use dry wood, open air controls, build a larger fire, pre-heat chimney |
| Fire goes out quickly | Lack of fuel, insufficient air, excessive draft | Add more fuel, open air controls, adjust flue damper (if present) |
| Cam kararır | Wet wood, insufficient secondary air, low burning temperature | Use dry wood, ensure proper air circulation, burn at higher temperatures |
| Internal stones crack | Normal wear and tear, rapid temperature changes, impact | Minor cracks are often cosmetic and do not affect performance. Replace severely damaged or crumbling stones. |
7. Özellikler
Below are the key technical specifications for the Prity K1 R Wood Stove:
| Özellik | Detay |
|---|---|
| Marka | rahip |
| Örnek | K1 R |
| Genel Boyutlar (U x G x Y) | 450x380x750 mm |
| Firebox Dimensions (L x W x H) | 370x295x350 mm |
| Ağırlık | 66 kilo |
| Nominal Heating Power | 9 kW |
| Baca Borusu Çapı | 130 mm |
| Malzeme | Steel plate (2mm body, 3-4mm top) |
| Yakıt Türü | Odun |
| Enerji Verimliliği Sınıfı | A |
| Yeterlik | %77.8 |
| Üretici | Prity 95 LTD |
Şekil 7.1: Energy label for the Prity K1 R wood stove, indicating an energy efficiency class of A and a nominal heat output of 9.0 kW.
Şekil 7.2: Declaration of Performance for the Prity K1 R wood stove, detailing essential characteristics, fire safety, emissions, and nominal heat output.
8. Garanti ve Destek
For warranty information and customer support, please refer to the documentation provided at the time of purchase or contact your retailer. Keep your proof of purchase for any warranty claims. For technical assistance or spare parts, please contact the manufacturer, Prity 95 LTD, or an authorized service center.
