1. Giriş
This manual provides essential instructions for the safe and correct installation and use of the LPG (Liquefied Petroleum Gas) conversion kit for the Flavel Milano G60 ML61ND 60 cm All Gas Twin Cavity Cooker. This kit is designed to adapt your cooker for use with LPG instead of natural gas. It is crucial to follow all instructions carefully to ensure safe and efficient operation.
This conversion kit is applicable to Flavel Milano G60 models including ML61NDSP, ML61NDK, and ML61NDWP.

Image: Flavel Milano G60 ML61ND All Gas Twin Cavity Cooker. This image shows the complete cooker unit, which this LPG conversion kit is designed for.
2. Önemli Güvenlik Bilgileri
UYARI: Yanlış kurulum, ayarlama, değişiklik, servis veya bakım maddi hasara, yaralanmaya veya ölüme neden olabilir. Bu ekipmanı kurmadan veya bakımını yapmadan önce kurulum, çalıştırma ve bakım talimatlarını baştan sona okuyun.
- Profesyonel Kurulum Gerekli: The installation and conversion of this kit must only be carried out by a qualified and registered gas engineer (e.g., Gas Safe registered in the UK). Attempting to install this kit without proper qualifications can be extremely dangerous and may void your cooker's warranty.
- Gaz Türü: This kit is specifically for converting the cooker to use LPG. Do not attempt to use it with natural gas or any other gas type.
- Havalandırma: Ensure adequate ventilation in the area where the cooker is installed. Gas appliances consume oxygen and produce combustion by-products.
- Kaçak testi: After installation, the entire gas system must be thoroughly checked for leaks using appropriate methods (e.g., leak detection fluid). Never use an open flame to check for gas leaks.
- Conversion Label: Affix the provided conversion label to the cooker in a visible location after the conversion is complete. This indicates the cooker has been converted to LPG.
- Çocuklar ve Evcil Hayvanlar: Cihazın kurulumu ve çalıştırılması sırasında çocukları ve evcil hayvanları cihazdan uzak tutun.

Image: Gas Safe Registered Logo. This symbol indicates the importance of using a qualified gas engineer for installation.
3. Kit Bileşenleri
The LPG conversion kit includes the following components:

Hob Burner Jets:
- 1 x 0.50 mm jet
- 2 x 0.72 mm jets
- 1 x 0.87 mm jet
Resim: Eskiample of an LPG hob burner jet. These jets regulate the gas flow to the hob burners.

Top Grill Jet: 1 x 0.75 mm jet
Resim: Eskiample of an LPG top grill jet. This jet is specifically for the top grill section of the cooker.

Main Oven Jet: 1 x 0.78 mm jet
Resim: Eskiample of an LPG main oven jet. This jet controls the gas supply to the main oven burner.

Conversion Label: 1 x Self-adhesive label to indicate LPG conversion.
Resim: Eskiample of a conversion label. This label must be affixed to the appliance after conversion.

Fiber Washers with Screws: 2 x Green fiber washers with screws for sealing connections.
Resim: Eskiample of green fiber washers and screws. These are used for ensuring gas-tight connections.
4. Installation and Conversion to LPG
This procedure must only be performed by a qualified and registered gas engineer.
- Elektrik ve doğalgaz bağlantılarını kesin: Before starting any work, ensure the cooker is completely disconnected from the electrical supply and the natural gas supply is turned off and isolated.
- Erişim Brülörleri: Carefully remove the hob pan supports, burner caps, and burner heads to expose the existing natural gas jets.
- Replace Hob Jets: Unscrew and remove each natural gas hob burner jet. Replace them with the corresponding LPG jets from the kit:
- Install the 0.50 mm jet into the designated burner.
- Install the two 0.72 mm jets into their designated burners.
- Install the 0.87 mm jet into its designated burner.
- Replace Grill Jet: Access the top grill burner. Unscrew and remove the natural gas grill jet. Replace it with the 0.75 mm LPG top grill jet.
- Replace Main Oven Jet: Access the main oven burner. Unscrew and remove the natural gas oven jet. Replace it with the 0.78 mm LPG main oven jet.
- Adjust Minimum Flame Settings: For each burner (hob, grill, oven), the gas engineer must adjust the minimum flame setting (often via a bypass screw on the tap valve) to ensure stable and correct low flame operation with LPG. This is a critical step for safe and efficient operation.
- Yeniden birleştirme: Reassemble all burner components, ensuring they are correctly seated.
- Connect to LPG Supply: Connect the cooker to the LPG supply using appropriate fittings and flexible hoses, ensuring all connections are gas-tight. Use the provided green fiber washers with screws where applicable for sealing.
- Sızıntı Testi: Perform a thorough leak test on all new and disturbed gas connections using an approved leak detection fluid. Rectify any leaks immediately.
- Test İşlemi: Test all burners (hob, grill, oven) at both high and low flame settings to ensure proper ignition and stable flame characteristics.
- Dönüştürme Etiketini Ekleyin: Permanently affix the provided LPG conversion label to a prominent and visible location on the cooker, indicating that it has been converted for use with LPG.
5. Operating Instructions (After LPG Conversion)
Once converted to LPG by a qualified engineer, the operation of your Flavel Milano G60 cooker will be similar to its natural gas operation, but with specific considerations for LPG.
5.1 Genel Kullanım
- Ateşleme: Turn the control knob to the full flame position and press the ignition button (if applicable) or use a match/lighter to ignite the burner. Hold the knob in for a few seconds after ignition to allow the thermocouple to heat up.
- Alev Ayarı: Adjust the flame size using the control knob. The flame should be blue and stable. A yellow or flickering flame may indicate an issue requiring professional attention.
- Havalandırma: Always ensure good ventilation when using gas appliances. Open windows or use an extractor fan.
5.2 Hob Burners
- Use appropriate cookware sizes for each burner to maximize efficiency and prevent heat loss.
- Do not allow flames to extend beyond the base of the cooking vessel.
5.3 Oven and Grill
- Yiyecekleri fırına yerleştirmeden önce fırını istediğiniz sıcaklığa ısıtın.
- Always keep the oven door closed during cooking unless specified otherwise for grilling.
- When using the grill, ensure the grill pan is positioned correctly and do not line it with foil, as this can impede air circulation.
6. Bakım
Regular maintenance ensures the longevity and safe operation of your cooker.
- Temizlik: Regularly clean the hob, oven, and grill surfaces with mild detergents and soft cloths. Avoid abrasive cleaners that can damage surfaces.
- Brülör Bileşenleri: Periodically remove and clean hob burner caps and heads. Ensure they are dry and correctly reassembled before use.
- Gas Supply Hose: Inspect the flexible gas supply hose (if applicable) for any signs of wear, cracks, or damage. Replace immediately if any damage is found.
- Yıllık Servis: It is highly recommended to have your gas cooker serviced annually by a qualified gas engineer to ensure it remains in safe and efficient working order.
7. Sorun Giderme
Before contacting a service technician, please check the following common issues:
| Sorun | Olası Neden | Çözüm |
|---|---|---|
| Brülör tutuşmuyor. | No gas supply, burner components incorrectly assembled, blocked jet, faulty ignition. | Check LPG cylinder/supply. Reassemble burner parts correctly. Clean burner jet. If ignition is faulty, contact a qualified engineer. |
| Alev sarı veya kararsızdır. | Incorrect air/gas mixture, partially blocked jet, incorrect jet size. | Ensure burner components are clean and correctly seated. If problem persists, contact a qualified gas engineer to check jet sizes and air adjustments. |
| Gaz kokusu tespit edildi. | Gaz sızıntısı. | Immediately turn off the gas supply at the source, open windows and doors for ventilation, do not operate any electrical switches, and contact a qualified gas engineer or emergency gas service. |
| Oven/Grill not heating correctly. | Blocked jet, faulty thermostat, incorrect gas pressure. | Contact a qualified gas engineer for diagnosis and repair. |
8. Özellikler
This LPG conversion kit is designed for the Flavel Milano G60 ML61ND 60 cm All Gas Twin Cavity Cooker.
| Bileşen | Jet Size (mm) |
|---|---|
| Hob Burner (Small) | 0.50 |
| Hob Burner (Medium) | 0.72 (x2) |
| Hob Burner (Large) | 0.87 |
| Üst Izgara | 0.75 |
| Ana Fırın | 0.78 |
Kit İçeriği: 6 jets (as listed above), 1 conversion label, 2 green fiber washers with screws.
Applicable Cooker Models: ML61NDSP, ML61NDK, ML61NDWP
Jet Thread Size: m6x0.75 thread and 7mm head (as per product specifications)






