Orbit 24620 1 Çıkışlı Hortum Musluk Zamanlayıcısı Kullanım Kılavuzu

giriiş

Thank you for choosing the Orbit 24620 1-Outlet Hose Faucet Timer. This device is designed to automate your watering schedule, providing convenience and efficiency for your lawn and garden. With its user-friendly interface and robust construction, you can easily program precise watering times, helping to conserve water and maintain healthy plants. This manual provides detailed instructions for setup, operation, maintenance, and troubleshooting to ensure optimal performance of your timer.

Önemli Güvenlik Bilgileri

• Read all instructions carefully before operating the timer.
• Do not immerse the timer in water. It is water-resistant, not waterproof.
• Use only fresh alkaline batteries of the specified type (e.g., AA or AAA). Do not mix old and new batteries or different battery types.
• Remove batteries if the timer will not be used for an extended period to prevent corrosion.
• Do not expose the timer to extreme temperatures (below freezing or above 120°F / 49°C).
• Sızıntıları önlemek için tüm bağlantıların sıkı olduğundan emin olun.
• Çocukların erişemeyeceği yerde saklayınız.

Ürün Bileşenleri

Familiarize yourself with the main parts of your Orbit 1-Outlet Hose Faucet Timer:

• Giriş Bağlantısı: Connects to your outdoor faucet.
• Çıkış Bağlantısı: Connects to your garden hose.
• Dijital gösterge: Shows time, program settings, and status.
• Kontrol Kadranı: Used to navigate through programming options.
• Düğmeler: For setting specific values (e.g., "SET CLOCK", "START TIME", "HOW LONG", "HOW OFTEN", "AUTO/MANUAL", "OFF").
• Pil Bölmesi: Located on the back or side, for battery installation.

Şekil 1: Ön view of the Orbit 1-Outlet Hose Faucet Timer, showing the digital display and control dial. The inlet is at the top, and the outlet is at the bottom.

Kurulum ve Yükleme

1. Pil Kurulumu

1. Locate the battery compartment on the back or side of the timer.
2. Remove the battery tray or cover.
3. İki (2) adet yeni AA alkalin pil takın ve doğru kutupluluğa (+/-) dikkat edin.
4. Replace the battery tray or cover securely. The display should light up.

2. Zamanlayıcının Musluğa Takılması

1. Dış mekan musluğunuzun kapalı olduğundan emin olun.
2. Thread the timer's inlet connection (top) onto your outdoor faucet.
3. Hand-tighten until snug. Do not overtighten.
4. Turn on your faucet fully. The timer is designed to operate under full water pressure.

3. Hortumun Takılması

1. Thread your garden hose onto the timer's outlet connection (bottom).
2. Sıkıca oturana kadar elle sıkın.

Şekil 2: Taraf view of the Orbit 1-Outlet Hose Faucet Timer, showing the robust construction and connections.

Kullanım Talimatları

The Orbit timer features a large digital display and a simple dial for programming. Rotate the dial to select a setting, then use the buttons to adjust values.

1. Saati Ayarla

1. kadranı çevirin SAAT AYARLA.
2. Saat yanıp sönecektir. Kullan + Ve - buttons to set the current hour (AM/PM).
3. Basın SONRAKİ Dakikalara geçmek için düğme.
4. Kullanmak + Ve - to set the current minutes.
5. Basmak SONRAKİ onaylamak için.

2. Başlangıç ​​saati

1. kadranı çevirin BAŞLANGIÇ ZAMANI.
2. Set the desired time for watering to begin using the + Ve - buttons for hour and minutes.
3. Basmak SONRAKİ onaylamak için.

3. How Long (Watering Duration)

1. kadranı çevirin NE KADARDIR.
2. Set the duration for each watering cycle from 1 to 360 minutes using the + Ve - düğmeler.
3. Basmak SONRAKİ onaylamak için.

4. How Often (Watering Frequency)

1. kadranı çevirin NE SIKLIKTA.
2. Frekansı ayarlayın:
   • Every hour (for short, frequent watering)
   • Every 6, 12 hours
   • Every 1, 2, 3... up to 7 days
3. Kullanın + Ve - buttons to select the desired interval.
4. Basmak SONRAKİ onaylamak için.

5. Auto/Manual Operation & Rain Delay

• OTO: kadranı çevirin AUTO / MANUALZamanlayıcı artık programladığınız takvime göre çalışacaktır.
• KULLANIM KILAVUZU: To manually water, turn the dial to AUTO / MANUAL, ardından tuşuna basın KILAVUZ buton. Kullanmak + Ve - to set a manual watering duration, then press GİRMEK to start. The timer will revert to AUTO after the manual cycle.
• YAĞIŞ GECİKMESİ: If rain is expected, you can pause your watering schedule. Turn the dial to AUTO / MANUAL, ardından tuşuna basın ve basılı tutun YAĞMUR GECİKMESİ buton. Kullanmak + Ve - to select a delay of 1 to 7 days. The timer will resume its schedule after the delay.

6. KAPALI

kadranı çevirin KAPALI to stop all automatic and manual watering. The timer will remain off until the dial is moved to another setting.

Bakım

Pil Değişimi

When the battery indicator on the display shows low power, or if the display becomes dim, it's time to replace the batteries. Follow the battery installation steps in the "Setup and Installation" section. Replacing batteries typically retains your programmed settings for a short period, but it's good practice to verify them after replacement.

Temizlik

Zamanlayıcıyı reklamla silinamp cloth to remove dirt or debris. Do not use abrasive cleaners or solvents. Ensure the battery compartment remains dry.

Kışlama

Before the first frost, remove the timer from the faucet. Drain any water from the timer and store it indoors in a dry, protected location where temperatures will not drop below freezing. Remove batteries before storage.

Sorun giderme

Özellikler

Şekil 3: Dimensions of the Orbit 1-Outlet Hose Faucet Timer: 7.62cm depth, 18.11cm height, 22.56cm width.

Garanti Bilgileri

Orbit products are manufactured with quality materials and workmanship. For specific warranty details, please refer to the warranty card included with your product or visit the official Orbit webSite. Satın alma belgeniz olarak satın alma fişinizi saklayın.

Müşteri Desteği

If you have any questions, require technical assistance, or need to troubleshoot issues not covered in this manual, please contact Orbit customer support.

• Webalan: www.orbitonline.com
• Telefon: Refer to the Orbit webbölgesel iletişim numaraları için site.