1. Ürün Bittiview
The Fantech FB 6 In-line Filter Box is designed to enhance indoor air quality by providing additional filtration within your HVAC ductwork. It is typically installed after an HRV (Heat Recovery Ventilator) or an inline fan to filter incoming air. This unit includes a MERV 13 filter for efficient particle removal.
Şekil 1: Dış view of the Fantech FB 6 In-line Filter Box, showing the duct connection on the left and the access knob on the right.
2. Güvenlik Bilgileri
Please read all instructions carefully before installation and operation. Failure to follow these instructions may result in property damage, injury, or death.
- Ensure power to the HVAC system is disconnected before installation or maintenance.
- Kurulum ve bakım sırasında uygun kişisel koruyucu ekipman (KKD) giyin.
- Consult a qualified HVAC professional for complex installations or if you are unsure about any steps.
- Herhangi bir parçası hasarlı veya eksikse cihazı çalıştırmayın.
- Eski filtreleri yerel yönetmeliklere uygun olarak imha edin.
3. Paket İçeriği
Kuruluma başlamadan önce tüm bileşenlerin mevcut olduğundan emin olun.
- Fantech FB 6 In-line Filter Box
- MERV 13 Filter (pre-installed or separate)
- Kurulum Kılavuzu (bu kılavuz)
4. Kurulum ve Kurulum
4.1 Kurulum Öncesi Kontrol Listesi
- Confirm duct size compatibility (6-inch duct).
- Kurulum ve gelecekteki filtre değişimi için yeterli alan olduğundan emin olun.
- Gather necessary tools (e.g., duct cutters, sealant, screwdriver).
4.2 Kurulum Adımları
- Konum Seçin: Install the filter box in the ductwork after your HRV or inline fan, ensuring it is accessible for maintenance.
- Kanalları Hazırlayın: Cut a section of the existing 6-inch ductwork to accommodate the filter box. Ensure clean, straight cuts.
- Connect to Ductwork: Slide the filter box onto the prepared duct ends. Secure connections using appropriate duct clamps or screws and seal with HVAC-approved tape or mastic to prevent air leaks.
- Verify Filter Installation: Open the access panel (refer to Figure 2) and ensure the MERV 13 filter is correctly seated.
- Güvenli Erişim Paneli: Close and secure the access panel using the provided knobs/screws.
Şekil 2: İç mekan view of the Fantech FB 6 In-line Filter Box with the access panel open, revealing the MERV 13 filter angled inside.
5. Operasyon
The Fantech FB 6 In-line Filter Box operates passively as part of your ventilation system. Once installed, it continuously filters the air passing through it. No user interaction is required for its daily operation.
6. Bakım
6.1 Filtre Değişimi
Regular filter replacement is crucial for maintaining optimal air quality and system performance. The frequency of replacement depends on usage and environmental conditions, but it is generally recommended every 3-6 months.
- Gücü Kesin: Ensure the HVAC system connected to the filter box is powered off at the circuit breaker.
- Açık Erişim Paneli: Loosen the knobs/screws on the access panel and carefully open it.
- Eski Filtreyi Kaldır: Gently slide out the old MERV 13 filter. Note its orientation for correct installation of the new filter.
- Yeni Filtre Ekle: Slide a new MERV 13 filter into the filter box, ensuring it is properly seated and oriented.
- Erişim Panelini Kapatın: Close the access panel and tighten the knobs/screws securely.
- Gücü Geri Yükle: Turn the power back on to the HVAC system.
7. Sorun Giderme
| Sorun | Olası Neden | Çözüm |
|---|---|---|
| Condensation/Sweating on unit (in cold climates) | Insufficient insulation around the unit, especially when used for fresh air intake. | Apply additional insulation around the exterior of the filter box to prevent condensation. Ensure proper sealing. |
| Access panel screws spin freely / do not tighten | Internal riveted nut may have come loose or stripped. | Carefully inspect the internal nut. If loose, attempt to secure it. If stripped, consider using a different fastening method or contacting Fantech support. |
| Filter does not fit perfectly or seal properly | Screw heads or internal components obstructing filter path; incorrect filter size. | Ensure you are using the correct filter size (e.g., 20x20x1 if adapting). Carefully position the filter to avoid obstructions. |
8. Özellikler
| Özellik | Detay |
|---|---|
| Model Numarası | FB 6 (CECOMINOD072653) |
| Üretici | Fantek |
| Kanal Boyutu Uyumluluğu | 6 inç |
| Filter Type Included | MERV13 |
| Ürün Ağırlığı | 10 pound (4.54 kg) |
| Paket Boyutları | 26.9 x 15.1 x 13.1 inç (68.3 x 38.4 x 33.3 cm) |
| Malzeme | 22-gauge galvanized steel with baked powder coat finish |
| UPC | 650737403041 |
9. Garanti ve Destek
Garanti bilgileri ve teknik destek için lütfen resmi Fantech web sitesine başvurun. websitesine gidin veya müşteri hizmetleriyle iletişime geçin.
You can visit the official Fantech store on Amazon for more products and information: FANTECH Store.
