Ciays 32 İnç Propanlı Ateş Çukuru Kullanım Kılavuzu

Önemli Güvenlik Bilgileri

Please read and understand all safety warnings and instructions before assembling, operating, or servicing this fire pit. Failure to follow these instructions could result in fire, explosion, property damage, personal injury, or death.

• Sadece dış mekan kullanımı içindir. İç mekanlarda veya kapalı alanlarda kullanmayın.
• Keep clear of combustible materials. Maintain a minimum clearance of 36 inches (91 cm) from the top and sides to any combustible construction.
• Benzin veya diğer yanıcı buhar ve sıvıları bu cihazın veya herhangi bir başka cihazın yakınında saklamayın veya kullanmayın.
• Always connect and disconnect the propane cylinder outdoors.
• Never leave the fire pit unattended when in use.
• Ensure all connections are tight and leak-free before operation. Perform a leak test with soapy water as instructed in the setup section.
• Çocukları ve evcil hayvanları ateş çukurundan uzak tutun.
• Do not use the fire pit if any part has been submerged in water.
• Ateş çukurunu taşımadan veya saklamadan önce tamamen soğumasını bekleyin.

Paket İçeriği

Before beginning assembly, ensure all parts are present and undamaged. If any parts are missing or damaged, do not attempt to assemble the product. Contact customer service for assistance.

Image: All components of the fire pit table laid out, including the main table top, side panels, door panel, cylinder holder, and lava rocks.

• Table Top with Burner (A)
• Door Panel Frame (B)
• Back Panel (C)
• Side Panels (D) - 2 pieces
• Cylinder Holder (E)
• Lava Rocks (G)
• Top Lid (H)
• Hardware Pack (Bolts AA, Control Knob DD, Battery EE)

Kurulum ve Montaj Talimatları

It is highly recommended to assemble the fire pit table using the unfolded box or another soft surface to avoid scratching the tabletop during installation.

1. Tabanı Hazırlayın: Place the main table top (A) upside down on a soft, clean surface to prevent scratches.
2. Attach Door Panel Frame: Attach the door panel frame (B) to the side of the table top that has the control knob shaft. Secure it with bolts (AA).
3. Arka Paneli Takın: Attach the back panel (C) to the opposite side of the table top. Align holes and secure with bolts (AA).
4. Yan Panelleri Takın: Attach the two side panels (D) to complete the enclosure. Secure them with bolts (AA).
5. Install Cylinder Holder: Attach the cylinder holder (E) inside the fire pit base using bolts (AA).
6. Install Door: Insert the bottom pivot of the door into the bottom hole. Then, pull the upper pivot down and align it with the upper hole. Release and fit the upper pivot into the hole to secure the door.
7. Propan Tankını Bağlayın: Place a standard 20lb propane tank (not included) into the cylinder holder (E). Connect the hose and regulator to the propane cylinder. Tighten the cylinder locking bolt to secure the propane cylinder.
   

   Image: Proper connection of the propane tank to the fire pit's regulator.
8. Pili Takın: Attach the control knob (DD). Remove the plastic cap from the igniter. Slide the battery (EE) into the battery slot. Attach and tighten the plastic cap.
9. Add Lava Rocks: Pour the lava rocks (G) into the burner area of the table top. Distribute them evenly around the burner.
   

   Resim: Yakın çekim view of the lava rocks in the burner area and the external control knob.

10. Sızıntı Testi: Before first use and after every cylinder change, perform a leak test. Apply soapy water to all gas connections. Open the propane cylinder valve. If no bubbles appear, the connection is secure. If bubbles appear, tighten the connection and retest. Do not use the fire pit if a leak is detected.

Kullanım Talimatları

Ensure the area around the fire pit is clear of any flammable materials before lighting.

1. Prepare for Lighting: Ensure the control knob is in the "OFF" position. Open the valve on the propane cylinder.
2. Brülörü Yakmak: Push and turn the control knob to the "ON" position while simultaneously pressing the igniter button repeatedly until the burner ignites.
3. Alevin Ayarlanması: Once ignited, continue to hold the control knob for 10-15 seconds to allow the thermocouple to heat up. Release the knob. You can then rotate the control knob to adjust the flame height from low to high.
4. Kapatma: To turn off the fire pit, turn the control knob to the "OFF" position. Close the valve on the propane cylinder. Allow the unit to cool before covering or storing.

Image: The Ciays 32 Inch Propane Fire Pit in operation, displaying a vibrant flame.

Bakım

• Temizlik: Regularly clean the exterior surfaces with a mild soap and water solution. Rinse thoroughly and dry completely. Do not use abrasive cleaners or harsh chemicals.
• Lav Kayaları: The lava rocks may accumulate soot over time. They can be cleaned by rinsing with water and allowing them to dry completely before reuse. Replace any cracked or broken lava rocks.
• Depolamak: When not in use, especially during extended periods or inclement weather, cover the fire pit with the provided top lid (H) or a weather-resistant cover. Store the propane cylinder in a well-ventilated area, away from direct sunlight and heat sources.
• Denetleme: Periodically inspect the hose and connections for any signs of wear, cuts, or leaks. Replace if necessary.

Sorun giderme

If you encounter issues with your fire pit, refer to the table below for common problems and solutions.

Bu çözümleri denedikten sonra sorun devam ederse lütfen müşteri desteğiyle iletişime geçin.

Özellikler

Image: Dimensional diagram of the fire pit table, indicating key measurements.

Garanti ve Destek

For warranty information or technical support, please refer to the product packaging or contact Ciays customer service directly. Keep your purchase receipt for warranty claims.

For additional resources, you may refer to the official Installation Manual (PDF) available at: https://manuals.plus/m/c734cd11bac333aac9e0c81a00307b110939b49a283da0641ad324e27cf8de44